So I finally got around to installing the new mountain bike grips. As expected, the installation went relatively smoothly. The only hitch that I noticed was that once the end caps were installed, it was difficult to determine if the grip was fully on the bar. It really came down to a judgment call. Ultimately, I figured if I tightened the outer ring first and did not notice any movement then I assumed it was in place.
The grips definitely feel more secure in my hands. I placed the large logo so that my palm falls naturally on top of it. This has created noticeably more cushion in palm than the Ritchey TGV grips they replace. I tightened the grips to factory specs. There is no side-to-side or rotational play in these grips. They are not going anywhere!
Even though both the TGV and Yeti Hardcore grips are designed for twist shifters, the Yetis are slightly shorter. In the photo below, you can see the gap between the inside of the grip and the shifter. That gap is the difference in length between the two. I have medium hands for an adult male and I cannot say I miss any of the extra length.
No comments:
Post a Comment